It is easily and quickly installed on the kitchen sink and fully replaces the traditional faucet. It is easy to use or maintain and serves everyday needs such as hand or dish washing.

It is equipped with a built-in digital display that shows you the water temperature and allows you to choose it yourself.

• Hot and cold water mixer tap
• Instant convenience
• Suitable and practical solution for every home
• Quick heating energy-saving
• Provides hot water in seconds (temperatures 30-60 °C)
• Design that works with low water pressure (0.04Mpa-0.5Mpa)
• Install only in rooms with temperatures above 0°C
• Install only in residual current protection networks
• LED display
• IPX4 protection category
• Countertop installation
• 3000W, 220-240V, 50/60 Hz

The instant water heater is a type of water heater that heats water in real time. It only heats the water that passes through it at that moment. There is no storage tank for hot water. This has many advantages, such as energy saving, as only the water that is used is heated, as well as longer lifespan, as there is no water tank and accumulation of salts in the heating element and other components.

It operates on electricity and is single-phase.

The instant water heater has a cold water inlet pipe, which passes through the resistance, heats up, and comes out in the hot water outlet pipe. A necessary condition for the instant water heater to initially operate is the pressure of the cold water inlet not being too low.

The temperature of the water is regulated by a thermostat, so as not to exceed an upper limit. The temperatures that the hot water reaches are pre-set so that someone can use the hot water directly, without the need to mix it with cold water.

The maximum temperature that can be reached for hot water production is 60 °C, while the maximum flow rate of water reaches up to 2.2 liters per minute. As an indication, 38-42 °C degrees are the standard for shower use.

• It is small in size and does not take up much space.
• There is no energy loss, as only the water that is being used is heated at that moment. Therefore, there is savings on the electricity bill. In a traditional water heater, the unused hot water goes to waste.
• The hot water used in the instant water heater is used as is, without mixing with cold water, as is the case with a traditional water heater. This also saves water, in addition to electricity.
• There is no need to wait for the water to heat up. As soon as we open the tap, hot water starts running in a few seconds. A traditional water heater takes some minutes, depending on its size.
• The hot water never runs out. As long as we have the tap open, we will have hot water.