The motor is powerful and has a nice and smooth start, and the blade is sharp. The upper part, the guard, and the switches look and work fine.

However, the base is the big problem. It is very flimsy, crooked, and even wobbles with small forces.

The cutting blades do not sit properly on the base because it is not straight and horizontal! So the cuts almost never come out at 90 degrees.

Because the base is not securely attached to the hinge point, the blade wobbles left and right, resulting in uneven cuts along the length.

When tightening the handle, the angle on which it grips the piece bends backward.

The edge of the handle is quite far from the blade, so when cutting small pieces, they tend to wobble.

In conclusion, I want to say that this purchase was DISAPPOINTING for the above reasons from a company that is considered a top in tools and is also very expensive!

I have it for 1 year now .. I don't handle it much but as much as I use it (I am an amateur) it makes very good cuts .. in the summer I will also buy the Femi NG120 !! .. it is much more expensive .. but it has cheap blades .. while the disc costs 150 Plus !!