Selected Store
Stock 5+ pieces
Skroutz Buyers Protection
Set the delivery location to see products according to your choice.
© 20[0-9]{2} Skroutz SA All Rights and Lefts reserved. FAQ | Terms of use | Privacy Policy | Cookie Policy
Selected Store
Stock 5+ pieces
Skroutz Buyers Protection
Washing Machines & Tumble Dryers Accessories
Washing Machines & Tumble Dryers Accessories
Washing Machines & Tumble Dryers Accessories
Washing Machines & Tumble Dryers Accessories
Washing Machines & Tumble Dryers Accessories
Washing Machines & Tumble Dryers Accessories
Washing Machines & Tumble Dryers Accessories
Prices are calculated for:Malta, Other Payment Options
Replacement carbon brushes for washing machines, compatible with Siemens, Bosch.
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.
In a 10-year-old Morris washing machine (WBW-81265/2) where the drum wasn't spinning, I immediately thought that the carbon brushes (in the motor) were to blame. I unplugged it, closed the water supply, and removed the inlet and outlet hoses. I turned it upside down and thought about fixing it myself.
I removed the old carbon brushes, which were quite worn down (less than 1 cm). The Morris carbon brushes were 13.5mm wide, 5mm thick, and the length of the spring with the wire was about 4cm, which I measured with a ruler I found in front of me (normally a brand new carbon brush would be over 3cm long).
Since I couldn't find readily available brushes for this specific model, I searched for ones with similar dimensions in length and width. I found some that are normally intended for BOSCH washing machines, priced at just 5E, with a thickness of 5mm but slightly shorter at 12mm. However, the important thing is that they make good contact with the rotor's surface because their height is approximately 35mm.
Now let's move on to the installation. The metal terminal that connects to the motor's cables was considerably smaller, so the electrical connection didn't fit properly, even though the carbon brush fit into the slot. So, what did I do? I cut off the wire from the old brushes along with their terminal and cut off the wire from the new brushes on the terminal side, then I removed the springs to make the connections without the wire pushing back. I twisted the wires tightly and added a bit of solder for better bonding. Finally, I reattached the springs by wrapping them from the edges upwards, and it was ready.
With the perfect fit of the small terminal that fits perfectly onto the cable and the cap that holds the carbon brush, they immediately fit and aligned. After I leveled the washing machine and plugged it back in, it finally worked, and the drum started spinning. So far, it has completed 3 wash cycles without any issues.
In conclusion, with a cost of less than 10E, if you take the time and effort and get your hands dirty, you can even fix your washing machine with carbon brushes meant for a different brand and model, without having to search for an available technician who might charge you around 40E and make you wait for their arrival and installation, not to mention the potential future damages that could increase the cost.
Of course, this applies only to electrical work. We unplug the plug from the socket and before plugging it back in, we check if it's dry, and of course, the anti-electrocution relay in our electrical panel should be functioning, as devices with a metal frame can be dangerous if there is a current leakage