The Radel Delonghi radiators have PHD technology integrated, based on which the flow of water is distributed first to the front surface of the body and then to the back surface. This asymmetrical circulation of water in the radiator has advantages that fully satisfy the requirements of thermal comfort, energy saving, and environmental respect. Heat is only delivered where it is useful, while unnecessary dispersion is minimized.

All Delonghi Radel radiators are tested at 13 bar pressure to ensure proper operation at 10 bar pressure.

The Radel bodies are painted in 3 phases:

• 1) Degreasing in hot phosphating with manganese material in hot.
• 2) Pre-painting with electrostatic method in an oven at a temperature of 180 °C.
• 3) Final painting with epoxy powder (Epoxy resin, polyester varnish RAL 9010) in an oven at a temperature of 160 °C.

• Construction material: Special sheet metal with deep stamping, thickness 1.25mm
• Maximum operating temperature: 110°C
• Connections: 4 ½” female threads for external loop bodies

In panel radiators, the switch enters from one side of the body and has an external tube that connects the top with the bottom of the radiator.

The type of columns is indicated by the number 22 (double column), which means it has 2 hydraulic columns and 2 welded manifolds to increase the heated surface.

The total thickness of the body is 10 cm.

It is very important to make the right choice of the radiator body according to the dimensions of your space. The sizing of radiators should be done by an engineer after studying the space and calculating the losses. The wrong choice of radiator can lead to insufficient heating or excessive heating of the space, resulting in energy waste.

A practical and simple way to calculate the required calories yourself is to multiply the height, width, and length of your room, in meters. Then multiply the result by the number 50, which represents an approximate estimate of possible losses.

However, this calculation method is indicative and does not replace the study that an engineer will do, which will be completely accurate.