Set the delivery location to see products according to your choice.
AustriaEnglish
BelgiumEnglish
BulgariaБългарски
CroatiaEnglish
CyprusΕλληνικά
CzechiaEnglish
EstoniaEnglish
FinlandEnglish
FranceEnglish
GermanyDeutsch
GreeceΕλληνικά
HungaryEnglish
IrelandEnglish
ItalyEnglish
LatviaEnglish
LithuaniaEnglish
LuxembourgEnglish
MaltaEnglish
NetherlandsEnglish
PolandEnglish
PortugalEnglish
RomaniaRomână
SlovakiaEnglish
SloveniaEnglish
SpainEnglish
SwedenEnglish
© 20[0-9]{2} Skroutz SA All Rights and Lefts reserved. FAQ | Terms of use | Privacy Policy | Cookie Policy
Sold by
Stock 1 piece
Skroutz Buyers Protection & 2 years warranty
Ceiling Fans
Ceiling Fans
Ceiling Fans
Ceiling Fans
Ceiling Fans
Ceiling Fans
Prices are calculated for:Malta, Other Payment Options
Specifications are collected from official manufacturer websites. Please verify the specifications before proceeding with your final purchase. If you notice any problem you can report it here.
The installation takes a little while, but it can be done by one person.
For me, the removable anchors, like sleeve anchors, in the packaging were not useful. When I started drilling the 2 holes, I realized that I had 6cm of insulation material until I found the ceiling plate. So, I needed anchors that allow for a material thickness of at least 7cm, and I bought wedge anchors (I found them on Skroutz in packs of 4) that have better strength. And make sure to get drills specifically for concrete or reinforced concrete, in two sizes, so that you can first open a small guide hole and then the regular one where the anchor will go. Don't forget to remove the dust from the hole, otherwise the anchor won't hold well. Be careful not to inhale or get the dust in your eyes. I first scraped it with a wire, having a damp cloth underneath, but it also needs blowing (at worst, with a straw).
Note that after installing the base, you should hang it assembled without tightening all the screws, almost the entire body except for the wings, lamp, and glass dome. For convenience, remove the screws for the wings beforehand.
Finally, when you put the bottom part with the lamp, be careful with the screwing, if you tighten it too much, it might go in crooked and hinder rotation. If you made the mistake of putting on the glass and tightening it too much (I did), know that it comes off relatively easily. If you pushed it too hard and it doesn't "unscrew," loosen it with a small screwdriver in multiple places (put the flat tip between the glass and the frame all around). It's better to test the fan before starting with the lights.
It doesn't have LED bulbs, but E9 socket (screw-in large), as mentioned in another comment.
For now, I'm using it on medium and I'm satisfied (I installed it during the hot weather of July 21). It won't cool the air (it's not an air conditioner), but it will provide a continuous breeze, especially if you're within its range (or better yet, cone of action).
I bought the fans last year for 65€ and due to travel restrictions, they stayed in another house in their box. I should have bought them for the other rooms as well.
Update:
I bought and installed 3 more in cherry, beige, and white colors. And I discovered some issues.
The white one is not completely white, but a silver body with white wings. I don't know if there is an all-white model, but with the silver body, the wooden-colored wings look much better.
One of them needs balancing or one screw needs more tightening because even at low speed, it shakes. Balancing has a process (I wait for the rotation to stop on its own each time, otherwise there is a risk of causing more damage). <-- The screws on the support were not tightened properly.
One of them was missing batteries.
One of the metal bases had smaller holes than the others. The diameter was fine for the provided screws, but as I mentioned, I prefer anchors with a larger diameter. So, I had to file them (I had a thin metal file, and it took about 10 minutes without much effort).
Now, I plan to solve the issue with the bulb by using a GX53 socket and bulb. <-- I changed the socket and now I no longer have the problem of the bulb illuminating one side more. I used double-sided tape and simply attached the GX53 socket in the center, it might need to be reattached in some time.
Attention, obviously filing and replacing the socket will affect/cancel part or all of the warranty.
Update 2023: They continue to work flawlessly.
Note for installers: prefer a distance between the anchors of ~11.5cm if your fan base allows it. I have encountered bases with different openings on different fans, which is logical since there is no standard. I provide the minimum and maximum openings, the screw or anchor should be within these, so calculate half the thickness of the screw/anchor:
8.5-12cm.
10-12cm.
10.5-14cm.
11-15cm.
For now, we have stayed with the installation... they do not unscrew at all. NOTHING the screws on the bases of the blades!!! We brought an electrician because we saw the reviews about difficulty in installation, but they are 2 strong men and they are trying to open them with a screwdriver and electric tool and nothing happens!! The person is forced to take off the bases, remove the screws I don't know how and bring them back... Unbelievable!!!
It's not for the bedroom. Every button press is accompanied by a loud "BEEP". Meanwhile, it has no memory. As soon as you press the switch, the light turns on, mandatory along with the beep. Then you need another beep to turn it off, and another one to turn on the fan. In short, there is no way you won't wake up completely, both you and anyone else sleeping with you, assuming you want to turn it on at night.
It's okay for shared spaces - strong and operates quietly. If only the annoying beep was missing (which cannot be disabled).
-1 star for the crappy instructions, missing screws, and different materials in each package (I bought three, one has a remote with 6 speeds, another with 3, etc.)
Otherwise, sturdy and effective.
If you have GYPSUM ROSETTES, I recommend:
- screws 7 or 8cm x 5mm
- size 8 plugs
- drill (size 8 drill bit) until you realize that you have entered the plaster and at least the depth of the plug (if the plug is 4cm and the rosette is 3cm from the plaster: drill 7cm)
- place all the screws in the metal base of the fan and the plugs on the edge
- hit with a hammer to properly insert the plug, and then screw it in.
Good luck
Flawless. With 6 speeds, quiet, simple weighing system with which I eliminated an imperceptible oscillation. Even at level 1, the air is quite noticeable. I would recommend it.
Quite good after a little use. On the plus side, the wireless controller, on the minus side, the beep that is heard every time you turn on the switch. Quite good and quality construction. Definitely for someone who doesn't have hands that can't manage to assemble it.
Very good fan with nice design and quiet. The negative thing I find is the manual, as it could be more detailed regarding the wiring connection so that you don't need an electrician. However, the assembly is easy. I recommend it.
P.S. The wiring in the repeater, as shown in the diagram, is unclear. The two wires on one side are phase-neutral to the power and the neutral, and the other three wires are for the cables coming from the light fixture.
I was satisfied with the same one I bought last year for 85€ and I bought it again for another room. It is 30€ more expensive. The low ladder doesn't work. I didn't bother with repair/replacement after reading experiences of other owners. Obviously, they don't go through quality/functionality control, so luck is needed.
I have had this specific fan in my bedroom for about 2 weeks now.
Relatively easy installation (requires 2 people), nice design & very quiet. It doesn't produce a lot of air, but it is sufficient for sleep even on hot days. You can find a strong light bulb if you want a lot of brightness, as the cover cuts off some of the light. The sound (beep) it makes when changing speed or turning on the light is a bit annoying.
Very good fan, quiet and cheap. I highly recommend it
This particular fan is beautiful in the room, high-quality, and quiet, but it doesn't provide any airflow at all. It's worth getting a floor fan three times cheaper than this one to get through the summer
Good quality. Quiet.
I received it 2 weeks ago and installed it with the help of an electrician in the bedroom (approximately 17 sq.m.). Obviously, due to the weather, I didn't use the fan for a while, but even on the 3rd speed, it is reliable, powerful, and doesn't make noise. On the first speed, if there is absolute silence, you only hear the air.
Its installation is difficult for one person and if you don't have an internal beam on the ceiling, you will need to put something like a support so that it is stable and you can have your head quiet (literally!)
The fact that it takes an E27 bulb is a BIG ADVANTAGE, as you can put a very bright LED. You will need this as the glass is opaque, so the lighting is slightly reduced.
The only negatives are:
1. When you turn on the light, the sensor makes a "beep", which some may find annoying, while others will simply overlook it.
2. Its socket is not vertical, but horizontal, which means that the bulb will only "look" towards one side of the room where you will place it, and the other side will be slightly darker. You can cleverly remove the socket from its position and place it vertically, but then the glass won't be able to close, so you will have the bulb filling the room with light on one hand, and hanging freely on the other. Choose and take your pick.
Overall, I am very satisfied with the purchase and would choose it again.
I have it in the kitchen, its only drawback is the lamp which goes "lying down from one side so the light goes one-sided. Overall, it was easy to assemble, quiet, stable, and brings strong air, rarely needing to go on the 3rd level
They had recommended it to me and luckily I listened to them. Beautiful in the space. It doesn't wobble so you feel like it's going to fall with the ceiling. The low intensity is indeed low. It cools without freezing the person underneath. It appears to be a particularly high-quality product. I recommend it to everyone
Good and quiet fan, works perfectly and its operation with the remote control makes it easier... It also comes in various colors, I love it
Very good airflow, relatively quiet and very stable.
All functions are performed through the remote control.
Even at the lowest intensity, it pleasantly and quietly cools! Very user-friendly thanks to the remote control. It's worth its money!
Very good, very quiet on the first speed, I have it in the bedroom and rarely need to put it on the second speed. It creates a breezy airflow in the room without hitting you in one spot like floor fans.
A worthy fan that definitely deserves its money.
At first, you are a little scared by the many components included in the package, but if you take them in order, it's easy.
The metal brackets included in the package are not suitable because they are too close, unless they are directly inserted into concrete without any gap.
With two F8 brackets, it's okay.
It doesn't need continuous power supply for operation, you can leave the switch as it is and the light will turn on when you switch it on with the remote control.
As for the bulb, it's E27, which I think is an advantage. You can use any bulb you want, regardless of whether it has an integrated LED panel
Definitely the installation should be done by an electrician or a knowledgeable person because the materials provided for the installation are not sufficient. It is a fan that you would expect to have a much higher price. Very convenient control for the light and the fan. The only drawback is the loud noise when turning on or off the light, as mentioned before. We were so satisfied that we bought a total of 3 for the bedroom and kitchen. You will definitely be satisfied!
Very good in everything, but loses in something small but ultimately important. The BEEP it makes every time I open or close it or anything else, wakes up my wife and the baby! If this doesn't bother you, then it's a good choice! I will try to lower it with a trick. If I can, I will update!
Just bought it...
Very stable (has a short arm)
Has good performance even at low speed
Very nice design
I can't find any negative aspect.
A good fan that will not disappoint you. However, one note. In the instructions in the diagram, it is mentioned that it has a whole LED plate, which is not true. There is a screw-in socket and it takes the bulb on the side, resulting in the light going to one side of the room and being darker on the other. The socket should have been vertical or should have had two sockets opposite each other so that it could take two bulbs.
That's why, my friend, you call an experienced person to install it, an electrician, since it has cables and you don't know...
And of course, you NEVER use the nails and screws of the packaging of any product
I bought it from a local store. The instructions in the manual have as much relation to instructions as a snail has to nuclear physics. After several trial and error attempts, I managed to install it correctly. If it had correct instructions and all the right screws and bolts and didn't require you to search every time for what you need and in what quantity, the installation wouldn't be a problem. For this reason, I give it four stars for the manual and the wrong screws and bolts
Verified purchase
Excellent, very satisfying even when you have it at 2.
Completely silent, not so efficient for very hot temperatures. A specialist installed it.
Verified purchase
Quiet, user-friendly, beautiful
Verified purchase
Value for money product
Verified purchase
It does not have a winter function as stated in the description
Verified purchase
No complaints at all...
