Fast printing
Easy connectivity.

The negative is the price now.

I bought it 2 years ago for 90-95€.

Exactly the same... And now it's 180€?

Starting with the positives... Good and high-quality printing, at a good speed, even in duplex mode.
The connection with the computer involves some inconvenience depending on the operating system.
However... its biggest drawback is the toner. It only accepts original ones, which are very expensive, and moreover, their chip has a "cut-off" feature, so once it exceeds the estimated number of prints, it stops printing even if there is still toner remaining.
Also, the calculation of pages is done with a specific percentage of printing per page. Therefore, the indicative number of pages of the toner is not at all feasible in real-life usage in an office.
Overall, it is a high-quality machine, but the limitations on the toner make it impractical for a large volume of printing.

Clearly the worst and most useless machine on the market!!! Constant disconnections to the point of disgust, and to reconnect it you have to be a magician.... It prints one page and disconnects, and it takes half an hour to reconnect it!!! To print 3 pages it takes 3 hours without any exaggeration!!! Stay away miles away!!!

Cheap to buy, expensive to use. Good printing quality but its toner is very expensive. I do not recommend it for those who use it frequently. I am an educator and every 3 months I have to buy a toner that costs at least 40 € for 1200 pages. Meanwhile, it barely manages to print 800 pages. So far, there is no compatible toner available on the market at a cheaper price.

One year later, the toner remains equally expensive and there are still no compatible ones available on the market. I am already looking for another printer.

Attention (for now) only accepts the purchase of genuine toner. Also, the pre-installed did not produce a single package of 500-page paper. I made the setting for low printing early on, but nothing changes. It has an internal board that counts the prints backwards and stops at the last one with a message even though the print quality was excellent. That is, it has toner and does not print. If compatible toner does not come out, I believe it is not worth buying it considering the expensive consumables. As a device and printing quality, it is excellent.

It does a little bit of banding, meaning that if you print photos, it produces lines, but otherwise it is excellent.

Good quality construction, good quality prints and fast, but it is practically very expensive as the toner runs out very quickly and in no case are the 1200 and 3000 pages of the toner replacements respectively complete. With daily limited use (average 4-7 pages), it lasts about 3 months for the 1200-page replacement. Also, it would disconnect from my wifi periodically on its own. Not at all a value for money product, I would not buy it again.

I bought it from a store for 90€, I have had it for over a year and it worked correctly only for the first 6 months without any issues. In terms of printing, I can't say anything, it produces a good image, I have it for work purposes only. In terms of connections, it has been a hassle all the time, it needs to be unplugged and plugged back in to work. If I have to print more than 3 files, this process needs to be done at least 3-4 times. So, I stay away from it. Its toner, although expensive, only produces around 1 package and not the 1200 pages it claims.

The toner "theoretically" lasts for 1200 prints. Theoretically. In practice, it didn't even print the 500 pages (not even front and back) of a pack of A4 paper, with text only and no logos, backgrounds, shadows, shapes, or diagrams. In other words, it can print around 300 pages that have no trace of an image, only plain text and nothing else. It is worth going to a print shop! This printer is definitely not cost-effective. The cost of a cheaper toner, 40 euros (or more!), divided by 300 pages results in a cost of 0.13 euros per page. Not even the most expensive shop in Europe charges 0.13 euros per page. The printing cost in the shops I have found is always around 0.4 euros per page. Unfortunately, I fell for Lexmark. It has unacceptably high printing costs. If we add the cost of the printer itself to the calculation, then simply, as another user of the product wrote: stay away. Never again Lexmark!

The worst printer there is.. eats all the paper, you print 3 pages it eats 2.. and you have to open it to retrieve what it ate... very poor construction...

I bought it a year ago for 70 euros. STAY AWAY!!! The toner lasts very little and costs 42 euros. And there are no compatible toners. In one year, I bought toner twice (2x42=84). With my previous laser printer, I used to buy compatible toner for 18 euros and it lasted one and a half years (8000 pages). FAR FAR AWAY!!!!

He is awesome. I have had him for 6 months. It's better to download the mopria print on your mobile from his own Lexmark because it sometimes has issues.

It's not my choice, a friend gave it to me as a gift! It's a good machine with a sturdy construction and prints very well! However... when the initial cassette runs out quickly, you will discover that there is no compatible toner and the new one costs 45 euros!!! My friend bought it in August 2020 and it cost him 75 euros... a good price. Today, as I write this note, its price is at 133 euros!! Why? I don't know.
And the secret... they say that the full cassette prints 1200 pages... but the company means with a coverage of 5% (!!!) of the page! That is, 200 regular pages at most!!!

We bought it for 90 euros and it has been a lifesaver! It prints quickly and is very easy to use. We are not familiar with it, so we struggled a bit with the installation. For laser, it's worth every euro

I bought it so I can work from home, printing 1-5 pages per day, the factory toner barely lasted for a month. The installation is quite easy and it opens quickly, but there is an issue when trying to print via WiFi, it doesn't always show up. The biggest problem I face is when I needed to change the toner, I had seen the price before buying it, it was slightly higher but its functions suited me, when I went to buy a new toner, it was a little cheaper than the printer and it requires a new drum every 2 toner changes... The cost per page is not less than 0.025 cents and I believe I made a very good choice.

Good evening, first contact with a laser printer for home use.

The quality seems satisfactory to me. From the moment I press print and it's in sleep mode, it takes about ten seconds to print the first page.

The setup seemed easy to me. I plugged it in, turned it on, set it up to connect to the wifi from the device, and on my computer, I had it search for new devices. It found it on its own, and now it's paired with all three of my computers

For 80 euros on offer, it is very good. After each print, the toner smells a little, which means it is not good to have it in a bedroom in general. It prints quite fast and with good quality. It is not worth 114€ that I see now as its price

Quality in printing but the installation is dramatically difficult, if I knew, I wouldn't have taken it. Lexmark did everything possible to make the installation difficult. Wi-fi installation, if it happens, drives you crazy, and then it constantly creates problems. I was used to the easy installation of Samsung but I don't know why, they are no longer available in the market.

Yes, he is fast, sturdy as stated in the rest of the comments, but... He displayed the need to replace the cassette on the screen quite early without even having printed 100 pages, no exaggeration! Also, the installation and recognition from the devices I needed to connect to were quite difficult! I expected something much better from this company, and having had an HP inkjet printer in the past, I regretted changing companies. Now I have to pay another 45-50€ just to say that I have a printer or buy a new one!

Good evening. I bought it a while ago and since I hadn't researched it beforehand, I tried to buy a new ink-toner. Unfortunately, I learned that it cannot be refilled nor is there a compatible one, which means that when I buy the next ink, I will reach the printer's price. What I mean is that I got it for 80+€ on discount and the ink costs 40€.

After a few years of use, I can say that this particular machine is definitely not worth its money.
- It constantly disconnects from the PC and takes a lot of time and hassle to reconnect.
- The toner barely lasts for 200 pages of plain text with a cost of 42 Euro.

Good printing, good construction but...the big but...300 prints with difficulty...I'm not talking about the first toner you mentioned, most companies only put half, I'm talking in general about everything...45 euros for the toner and it lasts very little...if there is no compatible toner to reduce the cost a bit, I will probably go for another printer...it's not worth it!!!

I use it professionally and I was completely satisfied with the choice. The only negative thing is that it did not include a USB and Ethernet cable.

Strange machine. For manual feed it doesn't have a tray and you have to insert the sheets one by one, something I have never seen before. Its consumables seem very expensive to me! Very nice print quality at a very good speed. I had a hard time making some advanced settings (e.g. to print A5 landscape) or to have a specific name on the network. Its web interface is very comprehensive but complex.

Very good product for individual use at home. It's worth the money. It's a bit bulky, but it works well and quickly!

Excellent printer, especially for the price of 70 euros it is available. It can be set up immediately from the mobile application for wireless connection, "wakes up" very quickly for the first print from "deep sleep". Compact construction and convenient size. "Beautiful" for a laser printer. Excellent purchase, I hope it doesn't disappoint me in the long run.

It is a very good printer and is considered semi-professional, it has difficulty connecting to the computer and you need a technician for the connection.

Very good and for its price it is very easy to install, you just download the application on your phone and simply connect it to your home's wifi and you can print from wherever you want from your home! It prints very fast and I recommend it!! Plus, it can turn the pages by itself! Oh, and one last thing, it also supports cloud printing for those who know.
I hope I helped!!

Easy installation from your mobile, clean prints and flawless wifi printing. Now it will show how long the toner will last in mainly document prints.
edit 17/5/21: After several prints but definitely not as many as the toner predicts (1200), I reached the point of replacing the toner, which costs half of the printer's purchase cost. It has caused several issues with printing from a PC, resulting in not allowing me to print from the computer at all. From mobile, it has no issues (8/10) and prints, but sometimes it doesn't detect the printer online even though I have connected it to the network both with a LAN cable and wifi for testing.

At first glance, this printer seems quite good and a good value for the money one would spend to acquire it. The reasons that made me choose it over other printers are:
1) Printer cost
2) Cost of toner and drum replacements
3) Wireless connectivity with all devices as well as cloud printing (I have not tried it yet).
4) The estimate I had read that it can print up to 1200 pages with a full toner (This is not true).
I give it 4 stars for all these reasons, I don't give it 5 stars for 3 reasons:
Relatively difficult installation and recognition by all network devices.
Poor support from Lexmark in terms of software.
The estimate at 93% showed 560 pages remaining and I printed a total of 36 pages front and back in good resolution above 600dpi and the ink dropped to 53%.
I recommend it for someone who wants to move away from spray technology and wants economical printing, especially for documents. Just be patient with the settings!